|
|
Speeder module for Kitserver 2010
=================================
- allows to alter the speed of the game: slow down or make it go faster.
HOW TO USE WITH KITSERVER:
~~~~~~~~~~~~~~~~~~~~~~~~~~
1. copy speeder.dll into your kitserver folder
2. edit the config.txt and add this line to the [kload] section (where
all other dlls are listed):
dll = speeder.dll
3. also, in config.txt, add the following section:
[speeder]
count.factor = 1.0
HOW TO CONTROL THE SPEED OF THE GAME:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
The "count.factor" setting in config.txt controls the game speed.
The value of 1.0 gives normal (default) speed. If you increase it, the
game will run faster, if you decrease it, the game will run slower.
Currently the range of [0.1 - 1.5] is supported, because going outside
of those bounds will likely make your system unstable.
Examples:
1.0 - normal speed
0.9 - slightly slower
0.4 - REALLY slow
1.1 - slightly faster than normal
1.5 - a lot faster than normal |
评分
-
查看全部评分
|
发表于 2009-11-9 14:40
收藏
分享
顶
鄙视